EQ_Tatsuguchi

@EQ_Tatsuguchi,

From the data that you have provided:
234_215_285_0_385_306_193_234

I am assuming that there might be hardware issues with photoreflector no.3

Are you residing in Japan?
Perhaps you can send us your device so we can perform a hardware check for you.

Best,
UnlimitedHand team

@EQ_Tatsuguchi

Thanks for the information.
From the data that you provided, it shows that the device is in fact outputting values into Unity, so the following setup should work.

A1) “Serial_Unity_Quaternion” in UH4Arduino0041.zip
U1) UH.cs: ver 0040(preset in UHDemo_GrapQuaternion40

However the 0 value of PR[3] does look odd. In section 1.0…[Read more]

@EQ_Tatsuguchi,

U1+A1 works fine on our environment.
U1+A2 is not always outputting muscle motion sensor values, we will fix it up.

Could I suggest that you try the following steps:

1. Compile “Serial_Unity_Quaternion” version UH4Arduino0041
2. Open up the serial monitor
3. input the character ‘c’

Please tell me if you see the values and if…[Read more]

@EQ_Tatsuguchi

We have updated the Graph Demo, please download the project and try once more.
http://dev.unlimitedhand.com/unitycontents.html

Arduino v.0044
Unity Plugin: Use the default plugin included inside the Project.

Please let me know if it works for you.

Best,
UnlimitedHand team.

@EQ_Tatsuguchi,

I will investigate the problem with the Graph Project and get back to you as soon as possible.

UnlimitedHand team

@EQ_Tatsuguchi,

Thanks for the inquiry.
We made changes to the way the angles are obtained in previous versions of the UH unity plugin. Arduino library v.0044 should work fine. Would you let me know which version of the UH unity plugin you are using?

Best,
UnlimitedHand team

@EQ_Tatsuguchi

Thanks for the inquiry.
I understand that you are not getting readings for your muscle motion sensors.

UH v0044 is the latest update. It is tested to be working fine.
May I know which version of the UH Unity Plugin are you using?

Best,
UnlimitedHand team

@EQ_Tatsuguchi

Thank you for your inquiry.
I understand that you wish to refer to the Unity code of the calibration test. Since we are still optimizing the software for calibration, we plan to publish the full version in a few months from now. Once it is released, we will open a new thread as a notification.Sorry for the inconvenience.

UnlimitedHand team