Reply To: My UH returns 255 from gyro sensor of X-axis with just putting on flat space.

Recent Topics Forums Installation & Troubleshooting My UH returns 255 from gyro sensor of X-axis with just putting on flat space. Reply To: My UH returns 255 from gyro sensor of X-axis with just putting on flat space.

#403
EQ_Tatsuguchi
Participant

    Hi H2L

    I try to check this issue by serial monitor on Arduino by advised in “http://forum.unlimitedhand.com/forums/topic/my-uh-receives-just-0-or-1-from-photo-reflector-no-3/”.
    The procedures are following.
    1) Compile “Serial_Unity_Quaternion” version UH4Arduino0041
    2) Open up the serial monitor
    3) input the character ‘a’ for display the raw values of the acceleration and Gyro sensors

    The result is following.
    503+640+-16893+32.365+255+0+-253

    When I check it, my device is put on desk with Photo-Reflectors facing to lightings in my office.
    So I don’t rotate and touch my device in checking, but Gyro[0] is 255(Gyro[2] is also not near zero).

    What do you think?
    Best regards,
    EQ_Tatsuguchi